SHAREBOT Next Generation Manual do Utilizador descarregar pdf (Página 33)

Putting in tension the extruder’s rubber bands

Your Sharebot NG is equipped with a cushioned versus pulley sprocket wire drag. This solution al-

lows to compensate for thickness variations that some laments can have, allowing you to bring the

press anyway.

The correct tension of the compensating Springs allows optimum lament drive.

Select the display “Prepare” menu the option “Change wire”. Wait until the machine ejector cycle

terms and once nished, insert the wire. While loading try to lock the thread with your ngers; If this

were to lead to a “slip” of the sprocket on the lament, tighten the springs until you have an outlet to

blow away the engine (you should hear a ping like a tak tak). Similarly, the springs must not be too

narrow to protect the motor is too under stress and consequently lose steps.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 65 66

Sem comentários

SHAREBOT Next Generation Manual do Utilizador Página 33